Hard water is broadly defined as water that has a high mineral content – the hardness or softness of tap water will often vary across different regions.
With water flowing through our taps, into sinks, baths and toilets, the high mineral content found in hard water can have some irritating effects, such as calcium and magnesium deposits which build up and can be tough to remove. But, thanks to Harpic Bathroom Cleaning spray it’s easy to remove hard water stains from your bathroom.
What causes hard water?
Water is a solvent, and when it rains onto areas of porous, sedimentary rock such as limestone, chalk or sandstone, the rainwater dissolves the chemical compounds within it. These compounds typically involve calcium and magnesium. The chemicals then leech into lakes and rivers, and into our water supply. Our water supply then travels through the pipes in our homes which can cause hard water issues when it ends up in our kettles, baths and sinks.
What removes hard water deposits?
When planning to get rid of calcium deposits, we recommend having the following tools and products on hand:
- A soft cloth to clean
- Harpic Bathroom Cleaning Spray
- An old toothbrush (for hard to reach spots)
- A microfibre cloth to buff
How to remove hard water stains
Frequently used areas like your shower, sinks, and baths are most susceptible to those unsightly hard water stains. Your bathroom can shine in no time, just follow these steps to clean hard water stains for good:
Step 1: Directly spray the Harpic Spray around the tub, bowl, or shower floor and leave for one minute.
Step 2: Wipe using a clean, dry cloth.
Step 3: Rinse thoroughly with warm water and buff to shine with a microfibre cloth, using small circular motions.
How to remove calcium deposits from tiles
The tiles surrounding your bath, shower and sinks are a typical spot for stubborn calcium deposits to build up, so you’ll need a good limescale and grime remover to do all the heavy lifting for you. Before you start tackling the tiles, please ensure you have proper ventilation. Always spot check on a small/hidden area before using the product.
Step 1: Turn the trigger nozzle of the Harpic Bathroom Cleaning Spray to the “ON” position.
Step 2: Directly spray the cleaner onto the calcium deposits and leave for one minute.
Step 3: Using the cloth wipe clean.
Step 4: Rinse roughly with warm water and wipe down with a damp cloth for a clean and shiny finish.
How to remove calcium deposits from faucets
Knowing how to remove hard water build up from taps is critical because it can be a troublesome and unsightly area of calcium build up.
To clean these tricky areas, follow the same instructions as you would for tiles, using Harpic Bathroom Cleaning Spray and allowing the product to sit for one minute before wiping.
Additionally, you may want to use an old toothbrush to allow you to rub the formula in to the difficult angles and crevices of the taps.
How to clean limescale from a toilet bowl
Unfortunately, even your toilet isn’t safe from limescale and the stains can make it look dirty and unhygienic – even if that’s not the case. The best way to clean limescale from a toilet is to have a toilet cleaner that can get into those hard to reach places. Harpic Power Plus is perfect for the job as the unique U-shaped bottleneck enables precise application to remove limescale from the toilet rim. Just follow these steps below to clean hard water stains:
Step 1 – Press the sides of the cap on your Harpic Power Plus and twist counter-clockwise to open.
Step 2 – Pour the liquid around the toilet bowl and under the rim for a full, deep clean.
Step 3 – Allow the liquid to spread and leave for 20 minutes.
Step 4 – Scrub the stain with the toilet brush and flush.
For more tips on how to get your faucets to shine, read our step-by-step guide on how to clean taps.
Though we cannot change the fact we live in hard water areas, by keeping a regular cleaning routine and using the right products, we can keep calcium deposits at bay.